Adapter Plate Installation Instructions
#10011
The #10011 is also equipped to fit the Ruger Recessed/Skelton composite stock with
the included adapter plate. (If you do not have this specific stock you may discard
the adapter plate) Simply unscrew the original stock pad and place the adapter plate
protrusion part down towards the inside stock hole. Use the provided screw and the
install the adapter plate using the middle screw hole. You are now ready to install
the LimbSaver recoil pad. (Please make sure you use the existing screws that came
with the stock)
#10201-#10200
The #10201-#10200 is also equipped to fit the same Mossberg with different screw
hole specs. If your screw placement is 15/16� from the heel to center of first screw
hole and 7/16� from toe end to center of first screw hole then you will need the
included adapter plate. Simply unscrew the original stock pad and place the adapter
plate beveled side down towards the inside of the stock. Use the provided screw
to install the adapter using the 3rd screw hole which is located 1 3/8� from the
toe end. You are now ready to install the LimbSaver recoil pad. (Please remember
to use the screw that came with your stock)
#10401-#10400
The #10401-#10400 is also equipped to fit the 12 ga. pop-in pads such as the Nova.
Simply pop out the existing stock pad and take the adapter plate with the tapered
side facing down toward the inside of the stock. With slight force you want to pop
the adapter plate inside the stock so it is sitting under the inner lip. Use the
provided 2 screws to install the LimbSaver recoil pad.